|
Increase Sensitivity of Receivers & Test Equipment - Broadband...from 1 MHz to 1000 MHz, usable to 2000 MHz
- Low noise figure, < 2.5dB
- Improves AM, FM, VHF TV, UHF TV, and HF reception. 50 - 75 ohm imp.
- Over 25 dB Gain with up to 100mW of power output
Ever wish you could "perk-up" your counter or scanner to read weak signals? Or how about boosting that cable TV run to drive sets throughout the house or maybe preamping that TV antenna to bring in that blacked out football game? The PR2 broadband preamp is the answer to all these needs as well as many others. You can use the PR2 anywhere a high gain, low noise amp is called for; digging out those weak shortwave signals or putting new life into that scanner radio - especially at 800 MHz. Since the PR2 has such a high compression point of almost 100 milliwatts, you can even use it to boost the power of small, micro transmitters! Newly designed microwave MMIC chips from NEC Japan enable the PR2 to have gain up to 2 GHz although we only spec the PR2 to 1 GHz (believe it or not the connector lead length is the limiting factor!). Customers tell us that the PR2 outperforms professional lab units by the "Big Boys" that go for hundreds of dollars more. The PR2 is the ideal general purpose RF amp that you'll wonder how you got along without. Runs on 12 VAC/DC or 120 VAC using the included wall adapter. Size: 4" x 2" x 1".
 
|
